Holley Hi-Ram throttle bracket fabrication

Eric

Owner
Staff member
Stormy Days(HC)
#1
So, I need a throttle cable bracket to fit my holley Hi ram intake.

The holley provided brackets costed 30$ and looked rather flimsy... so, I decided to craft my own.


I started with some 1/2" bar stock, and drilled a few holes to match the mounting holes.

20180606_193146.jpg


Next, I cut out a piece of 1/2" 16ga square tube.
20180606_193946.jpg


And a few end caps for the tube, along with a second piece of bar stock, to make a beefier bracket to mount with.
20180606_194337.jpg


I welded the two pieces of bar togather.
20180606_195156.jpg


Test fit, to ensure it fits properly.
20180606_193637.jpg


Next I welded the square tube to my bracket.

20180606_201009.jpg
20180606_200113.jpg
20180606_200913.jpg


Lastly, I welded the final piece of bar stock to the tube, and drilled a few separate holes for holding the throttle cable.

Then, I cleaned everything up, and mounted it.
20180606_203453.jpg
 
Top